Salomon s 912 ti (Page 2)

Linto
21/04/2004
Dirty bond! The backbone paused after five days of skidding, and Salomon had no more so I've had a drive with them until the new model comes out. Although it may be a small plus that I get next year's bond. After 15 days of skis and a couple of small crashes, it also picks up the dressing so that it always leaves thief. Dangerous.
+ Fucking handsome
+ That I get one new to the start of the next session
- The binding both front and back has been tied
- That Salomon had no more
- That I've had a kiss
Hope that next year's bond is better ....

Translated by Google  ・  Show original
skidnarkoman
24/03/2004
light and comfortable. have only thrown 2 times in 2 seasons. Otherwise, only resolved when they should. minus because the backbone broke into one pair. but I got a couple of new ones after just over a week ...

Translated by Google  ・  Show original
N/A
17/02/2004
Certainly they work, but they could have been a bit better.
I made 180 yards over a ditch when they got out and then they broke down, they said so, and they are asking themselves a little anyway.
Now I have a new couple and hope they are doing better.

Translated by Google  ・  Show original
Kampe
28/11/2003
Absolutely ok bindings simply work well

Translated by Google  ・  Show original
skibum2004
23/10/2003
Skit binding has cracked three pairs ... Luckily, everybody got new every time but a lot of hassle. Is the plate behind that cracked at jumping ...

Translated by Google  ・  Show original
Knugen_Faller
23/10/2003
Seems that it's a completely ok binding. Have not had any problems with it :)

Translated by Google  ・  Show original
Dan_ne
08/10/2003
Not the world's best bindings according to me! have loosened some plastic pieces here o there from them! Feels a little plastic simply

Model year: 2002
Translated by Google  ・  Show original
Deliver
04/06/2003
Cannon tie which, in my opinion, worked very well ... However, I have only run it for about 25 ski days so I can not give an opinion on the "durability squad".

But as I said, so far it works without remark and resolves when it's going to

Model year: 2002
Translated by Google  ・  Show original
Rockard
11/05/2003
My stoppers have broken, they do not hold. and the connection breaks down after a while you have to tighten it even otherwise it will not work well. now my other stops start breaking too, otherwise pretty good binding nice :)

Model year: 2001
Translated by Google  ・  Show original
Bajsmatte
07/05/2003
Uses the screw that regulates the width of itself. In addition, it dissolves more easily than it should do if you look at how hard it was drawn.

Model year: 2002
Translated by Google  ・  Show original